Digital Monitoring XR5 Guia de Instalação descarregar pdf (Página 15)

Page 11

Installation

2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282

XR5FC/XR5SL Installation Guide

Telephone RJ Connector

14.1 Description

Connect the panel to the public telephone network by installing DMP 356 RJ Cables between the panel's J4

(MAIN) and J5 (BACKUP) connectors and the RJ31X or RJ38X phone jacks.

14.2 FCC registration

The XR5FC and XR5SL panels comply with FCC part 68 and are registered with the FCC.

Registration number: CCK USA - 18660 - AL - R

Ringer Equivalence: 1.1B

14.3 Notification

Registered terminal equipment must not be repaired by the user. In case of trouble, the device must be

immediately unplugged from the telephone jack. The factory warranty provides for repairs. Registered terminal

equipment may not be used on party lines or in connection with coin telephones. Notification must be given to

the telephone company of:

a. The particular line(s) the service is connected to

b. The FCC registration number

c. The ringer equivalence

d. The make, model, and serial number of the device

Reset Jumpers J9

15.1 Description

There are two reset jumpers located at the top right of the panel's circuit board labeled RESET. Momentarily

shorting these jumpers allows you to reset the microprocessor of the XR5FC and XR5SL panels allowing you to

enter the internal Programmer.

You can reset the panel while the system is operational (for example, during a service call) without powering

down the system.

After resetting the panel for programming, you must begin within 30 minutes. If you wait longer than 30 minutes,

you'll have to reset the panel again.

Silence/Reset button

16.1 Silence/Reset button

The XR5FC and XR5SL panels each contain a mechanical push button located on the top center of the printed

circuit board that allows authorized users to silence alarm bells or sirens and reset latched detection devices.

After pressing the button, the panel silences the Bell output (XR5FC terminal 5) and momentarily drops power to

the auxiliary output (XR5FC terminal 6), the 377 Trouble Annunciator Module, and zones 2 to 5 (both panels).

Additionally, any Fire or Supervisory event displays at the keypads are also cleared. A 2-pin reset header is also

provided for use with keyswitches.

Dual Phone Line Connectors

17.1 Description

The XR5FC and XR5SL panels contain built-in dual phone line capability that allows the panel to monitor two

phone lines, indicate a phone line failure, and switch to the alternate phone line to communicate alarm and

system reports to a central station.

Before sending a report, the panel verifies whether the main phone line is working. If not, the panel sends the

report over the backup phone line. An integrated phone line monitor circuit continually tests the phone lines and

indicates a trouble condition on the line after 90 seconds. If the phone line restores and is good for 90 seconds,

the panel ends the phone line trouble indication.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Comentários a estes Manuais

Sem comentários

Digital Monitoring XR5 Guia de Instalação Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Detetores de fumo Digital Monitoring XR5